Showing posts with label lost wax. Show all posts
Showing posts with label lost wax. Show all posts

Tuesday, 8 October 2013

Glasswork: using cold glass.

This week in glass we were doing more work using cold glass. I designed and made a tile from two sheets of glass, with copper wire and copper foil inside for the decoration. I wanted to stay with the nature theme so I cut leaves out, and then used the copper wire and small pieces of copper foil to make it look as though it was windy, like the leaves were being blown about.


i washed and dried the glass sheets carefully, so as to not leave any marks on them, because the marks would stay there through the firing.
The tiles were put in the kiln on ceramic fibre paper, and were fired up to 810 degrees, so the glass sheets were fully fused together.

We then filled the moulds we made in the last session. for the half-mould, I filled it up to about twice its depth, because it needs more glass than it looks like it should to make up for the air in between the glass pieces.
these were then put into the kiln to fire, so the pieces of glass would melt and fill the mould. 

I weighed out the glass for my rose mould, using a glass:wax ratio of 2.55:1. my wax weighed 87g, and so i calculated that i would need 221 grams of glass. I weighed out 225, in case some of the glass stuck to the inside of the reservoir instead of all flowing into the mould. These were also put into a kiln, on ceramic fibre paper in case any of the glass overflowed and dripped onto the kiln floor.





Sunday, 6 October 2013

Glasswork: Steaming and carving the moulds

To create the mould for my rose, i had to get all of the wax out of the plaster to make the cavity i would then put glass in. I did this by putting the mould on top of a steamer (the same kind you use to take wallpaper off) which melts the wax, because steam is 100 degrees. the heat makes the wax liquid, which then runs out of the mould. this is one reason not to have any pieces sticking out so the wax can't get out, and the glass can't get in. any leftover wax could distort the shape and discolour the glass, so it is important to make sure there is no wax left in the mould.
 The wax came out of the mould and solidified underneath as it cooled.
 when no more wax was coming out of the mould, I flushed it out with hot water from the kettle, then cold. the hot water melted any remaining wax, and the cold water made it solidify again and float to the surface to be poured away. I repeated this until no more wax came out. I then put it in the drying cupboard.

I then carved into a plaster block to create a negative mould. i had to make sure it was deep enough to not snap if it were cast in glass. i used a leaf as my design, but simplified it slightly to make it easier for the glass to get into all the corners.


i carved the veins, so these will be stuck out when i cast it in glass.